Three effective cooling methods for prefab metal workshop building

There are three very effective, efficient and cost-effective treatment schemes for temperature reduction in the prefab metal workshop building:

1. Overall cooling plan

All environmental friendly air conditioners are selected for cooling, which are applicable to those with specific requirements for the temperature in the prefab metal workshop building. The prefabricated steel workshop area is large, the space is huge, and the personnel are dense. The air quality of the workshop is poor due to various environmental pressures, and the environment is sultry.

In order to achieve a better cooling effect, the overall cooling scheme is generally selected, and environmental friendly air conditioning is one of the commonly used equipment in this case. An environmental friendly air conditioner can cover an area of more than 100 square meters. It uses electricity for one hour, with small power consumption, large wind pressure, far air supply, good effect and fast cooling.

If the area of the prefab metal workshop building is too large, the whole heat dissipation can be combined. For example, the combination of environmental friendly air conditioners and industrial large fans is “fan complementation”, or the combination of environmental friendly air conditioners and negative pressure fans, and the devices are installed according to the size of the environment.

The overall cooling scheme can rapidly reduce the temperature of the whole plant by 4-15 degrees, ensure that the whole plant is ventilated within one minute, and the stuffy air in the whole factory is continuously discharged, which can also remove the odor and increase the oxygen content.

2. Post cooling plan

For plants with large area but few personnel, it is generally recommended to use rear air supply (cooling) for cooling. Many steel structure factories are in the state of half warehouse and half workshop, and only local areas are operated by personnel. In this case, the post cooling scheme is suitable for use, and no cooling will be carried out in unattended areas. That is to say, local air supply cooling shall be carried out for each post, and no cooling is required for the storage area of goods and products. The problem of personnel cooling can be handled specifically, and the cost of investment will not be too large, which should be controlled within a reasonable range. The cooling plan is an economical and practical cooling plan for prefab metal workshop building, which deals with the problem of personnel cooling and keeps the cost to the minimum.

3. Fan supporting scheme

Large industrial fan (building height more than 4m) and environmental friendly air conditioner are installed in the prefabricated steel workshop. After professional planning and calculation, combined with the practical needs of customers, the two products have obvious advantages. Science complements each other, and the advantages of the two products complement each other. While playing their respective roles, they also make up for each other’s lack of efficiency, so as to achieve the goal of ventilation and cooling for all. Lowering the material cost of air conditioning ducts is a very good low-cost solution for cooling large factories and warehouses.